Automatic Dynamic Balancing Machine

Automatic Dynamic Balancing Machine

Automatic Dynamic Balancing Machine is mainly suitable for dynamic balance correction of the rotor of DC micromotor.

Automatic loading and unloading of the assembly line, automatic separation after the rotor is qualified, simple operation.
It can be operated by a single machine, can be connected to a fully automatic rotor production line, and can be equipped with an MES system.
According to the characteristics of the workpiece, it can be drilled in angular (chamfering), radial and axial directions to remove weight, The main electrical components adopt brand components, and the equipment performance is stable and reliable.
Soft-supported high-precision measurement system, high accuracy of measurement data and good repeatability.
Fully independent intellectual property rights, special products can support highly customized solutions.
Photoelectric safety protection, automatic alarm and shutdown when failure occurs.

TECHNICAL PARAMETERS

Five-station I-type Automatic Dynamic Balancing Machine
Item	Machine Specification
Machine name	Five-station I-type Dynamic Balancing Machine Embedded software product – automatic motor rotor balancing machine control software V3.0）
Model no.	BDXST-5LI-B
Main components specification	Cylinder : SMC
	Servo motor : Yaskawa
	Sensor : KEYENCE, CONTROLWAY,ZHONGHANG
	Touch screen : KEYENCE VT5-X10
	Control PLC: KEYENCE KV-3000
	Stepping motor: Oriental motor
Rotor apply range	Rotor stack length:11-50mm
Rotor apply range	Rotor diameter: Φ15-34mm
Speed	Around 2100rpm
Cutting method	T cutter or V cutter
Power supply	AC380V
Air supply	0.4~0.6Mpa
Allowable initial unbalance	According to the rotor
Cycle time	5.5s
Residual unbalance	Better than G6.3
Volume	1700 x 1300 x 1800 mm

Remark: Based on actual specifications (can be negotiated according to customer’s requirement)

if you have any question about product detail please

MARKETING POLE GROUP

Central Office TEL: 0098 5138407354

Email : info@marketingpole.com